Posted by David K on June 16, 2003 at 19:27:46:
In Reply to: Re: carbon buildup on vacuum piston posted by Richard fssnoc#4368(Ks) on June 16, 2003 at 16:21:48:
RICHRD SAYS:
"I have a question about the needle clip plate, however. Mine has two (2) holes showing through the slide. Depending on how you install it, it can also be reversed to show only one (1) hole through. Which is correct?"
I do not understand the extra holes myself. How ever if the clip plate was wrong it would effect the operation ALL OF THE TIME. It could not produce good running and then bad running!?
The service manual says: "CAUTION, when re-installing the lock plate, align the holes of the lock plate with the piston holes!"
Also place the tongue of the diaphragm to the carburetor properly.